On March 14, 2011 at 08:41, Jasonvp said...
Personally I have never had this problem because the remotes I program send RC5 codes correctly.
Try sending VOLUME UP (T=0) & DIGIT 1 (T=0) together or VOLUME UP (T=0) & DIGIT 1 (T=1) together or all three.
VOLUME UP (T=0)
Device Code: 21 Function: 16
0000 0073 0000 0009 0020 0020 0040 0040 0040 0040 0040 0040 0040 0040 0040 0020 0020 0020 0020 0020 0020 0CC5
I'm guessing these are the correct codes. If not please post it.
DIGIT 1 (T=0)
Device Code: 21 Function: 1
0000 0073 0000 000A 0020 0020 0040 0040 0040 0040 0040 0040 0040 0020 0020 0020 0020 0020 0020 0020 0020 0040 0020 0CA4
DIGIT 1 (T=1)
Device Code: 21 Function: 1
0000 0073 0000 000B 0020 0020 0020 0020 0020 0020 0040 0040 0040 0040 0040 0020 0020 0020 0020 0020 0020 0020 0020 0040 0020 0CA4
OR
VOLUME UP (T=0)
Device Code: 21 Function: 16
0000 0073 0000 0009 0020 0020 0040 0040 0040 0040 0040 0040 0040 0040 0040 0020 0020 0020 0020 0020 0020 0CC5
VOLUME UP (T=1)
Device Code: 21 Function: 16
0000 0073 0000 000A 0020 0020 0020 0020 0020 0020 0040 0040 0040 0040 0040 0040 0040 0020 0020 0020 0020 0020 0020 0CC5
The above two will send VOLUME UP twice though.
Jason
Just got time to test, and what you send me absolutely works, you're good.
I don' know how you figure out the T=0 and T=1 code for each but you did.
However I just realised it does not solve my problem because as you mentionned it increases the volume twice (that could be acceptable) but then it also forces me to enter channel 11 instead of channel 1 (more of a problem).
The other issue it creates is that a 0.5 second delay is required between the 2 commands (otherwise it won't take the second one)
Gosh I hope I won't have to change my receiver because of this problem.
I can't believe there is no solution...
Thanks