I installed RA2 5 button keypad with ir, Main repeater, 3 switches, i used the pc program to set up repeater and keypad buttons. that works great.
Using the mx3000 software i used the lutron graphiceye codes(told to use by lutron support). scenes 1-4, raise and lower work good. Scene 5 code will not work.

I tried other scenes to see if they would work but no other codes would work.

I Have this info from a dist handout...

Category---------Specification
ir carrier freq------40.0khtz
duty cycle---------40%
single bit time-----2.288ms
baud rate---------437 bps
command length--36bits
command duration--82.368 ms


remote button----ir code (hexadecimal)
irb 3----ff88bd2b0h
irb 4----ff88bd710h
irb 5----ff88bd7e0h

I have the other ir codes but peck and type is slow and those codes work. Well 3 and 4 work but figured i would add them anyway.

Question How can i use this above info to add the correct code in to the mx3000 using the mx 3000 editor ? I do not know how to add hexadecimal codes into the mx3000 editor yet. so some info on how to do that would be great as well.

I have the mx-850, mx-700, tx-1000 editors as well. If they may be useful.


shout out to Jasonvp Your work on the samsung Discrete codes helped me on this job. Thanks A Bunch Man!!!!!!
[Link: remotecentral.com]