Post 21 made on Friday January 14, 2011 at 20:56 |
shorton Long Time Member |
Joined: Posts: | December 2004 146 |
|
|
OK. Back at it today. Yesterday's problem had to do withthe way the Makehex gui opens a notepad window and pasting issues. Worked that out, redid all the codes in hex on the remote.
But My remote (URC MX-980) will not send a single command, It apparently sends them in bursts. The left-right controls for example are used to control sliders that move in increments of 1.
When using the stock remote, I have no trouble getting the control slider to move by 1. But, with the MX980 using my programmed codes, left moves by 4's, no matter how quick or lightly I press the button.
In IR Scope the identical pressing results in a capture that says zero dittons for the stock, but oddly for the MX980 is shows 2 dittos. I expected to see 4. Same thing, no matter how lightly I press the IRwidget and IRScope combo report 2 dittos.
Is there any way to help the 980 avoid this behavior? Can I add a "Space" to the end of the IR code?
Is there anything I can provide so you can help me debug?
Thanks again.
Scott
|
|
|
|