Your Universal Remote Control Center
Harmony Remote Controls Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 11 made on Wednesday December 15, 2010 at 09:59
Active Member
December 2005
On December 14, 2010 at 19:23, eddieras said...
thanks- i'm not sure i follow you - regarding 'safe mode'. how is that done? thank you so much for your assistance!

Remove the battery from the remote, then while holding the Off button, replace the battery, the display should say Harmony Safe Mode, connect your remote to your PC and then do a Firmware update, followed by Updating your remote to restore your settings to the remote.

Hosting Services by ipHouse