Your Universal Remote Control Center
RemoteCentral.com
RS-232 & IP Control Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 7 made on Wednesday October 13, 2010 at 19:02
TouchCommander
Active Member
Joined:
Posts:
December 2004
591
Tech support said that there was no Baud rate setting in projector, but I bet there is. Tried your suggestion, no go. In hyper terminal do you select Xon, Xoff- hardware- or none in configure? Also do you use send line ends with line feed in AsCii setup?
No job to small, many to big


Hosting Services by ipHouse