Hi there,
I have searched over 100 threads but have not found a solution. I have the latest firmware on my RFX9400 & TSU9600. I have made a file that runs well without the extender.
When I added the extender it works OK but if I have 2 commands on a button e.g TV On, amp on, jump to TV the TV will switch on but the amp (being the 2nd command) is ignored & then it jumps to the TV panel.
Any channels that have 2 numbers are not executed at all. e.g channel 10 will not even execute the 1 first.
When I go to power off my devices only the first device is powered off & no other devices switch off.
I have set 0.5 second delays & still have had no success. I am using stand alone mode. The network option is greyed out in the PEP2 editor. Can anyone suggest a fix for this also? I am hoping that there is a simple fix, any help would be appreciated.
Last edited by manc01 on September 4, 2010 05:27.