On August 15, 2010 at 19:06, sofa_king_CI said...
This is a simple setup. Basically the Dining & Kitchen were intended to be one big zone with a single PTL4. The client is wanting to separte the zones but be able to link them back up when desired.
Basically the link would really just be to turn the 2nd zone on and make the volume control become a master for the two zones together. Maybe it would be easier to just add a volume UP/Down for the OTHER zone?
I assume you are programming this in SB? Use the connect command in SB and setup a macro, so each source output from the first zone will connect to the same source on the 2:nd zone. Make sure you link all the sources you are using.
You will then do the same on the off command as well as the volume command.
Your "Global/Party mode" button will then connect and disconnect the signals as a toggle.
There are a couple of pages on Crestron's site that gives maybe better detail then this as well.
[Link: support.crestron.com][Link: support.crestron.com]